Posts: 18
Threads: 12
Joined: May 2020
Reputation:
1
on iVentoy, Windows 11 will not install on my optiplex 3050. BIOS is set to AHCI. Windows will install fine with Ventoy on USB. When booted from iVentoy, the Windows setup prompts for drivers. If you press Shift-F10 while in windows setup and run DISKPART, I can see all of the disks.
Is there something I need to change?
Posts: 10
Threads: 2
Joined: Jun 2023
Reputation:
0
I had the same issue, for me it was a damaged iso.
Try redownloading actual windows11 with mediacreationtool
all unattend then you do with iventoy. tried to integrate but it wont load, if you go to image settings you can add a xml fle to each iso and also menu or autoboot
Posts: 18
Threads: 12
Joined: May 2020
Reputation:
1
I am using the same MSDN ISO from my USB stick that has Ventoy on it and it works fine, the ISO is not damaged.
Posts: 1,357
Threads: 85
Joined: Apr 2020
Reputation:
132
What about the latest 1.0.07?
Posts: 18
Threads: 12
Joined: May 2020
Reputation:
1
No it does not work still, even with 1.0.08.
I tried uploading a picture, but the attachment was too large.
As I said before, if you boot to Windows 11 (MSDN June 2023, Consumer Releases), you immediately get a prompt to install drivers. If you press Shift-F10 and go to the command prompt, and type DISKPART and then LIST DISK, I can see my drives.
Posts: 1,357
Threads: 85
Joined: Apr 2020
Reputation:
132
press Shift-F10 and go to the command prompt, then run
type X:\windows\system32\ventoy.log
type X:\windows\system32\ventoy\vtoype.log