Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
 ISOs in Ventoy partition not visible
#34
I guess it is always a possibility that the USB drive is faulty but when I do a file compare of the more than 10 ISOs I have copied to it with the original ISOs on my computer they are identical. I therefore deem it unlikely that the USB drive is faulty.

The working Ventoy FAT32 partition is 31GB and the exFAT was the exact same size. When I had it formatted as exFAT I could see the various ISOs when I mounted it on a running CentOS system, I just could not see any ISOs when I booted it on any of the four computers I tried it on. Plugging the USB stick back into my running CentOS system they were visible and a file compare was good. Now when I have it formatted as FAT32 I can view and boot the ISOs as expected.

So, I am back at my original question: Do I need to make sure the exFAT driver is active in Ventoy somehow? How can I make sure it can be loaded? Maybe there is something wrong with the configuration of Ventoy on my stick when I installed it?

I think I found some old posts about problems booting from exFAT on the forum.
Reply


Messages In This Thread
ISOs in Ventoy partition not visible - by garta34 - 03-31-2023, 07:36 PM
RE: ISOs in Ventoy partition not visible - by garta34 - 06-04-2024, 07:49 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)