WinPE 10-8 Sergei Strelec ?

[zxy]

WinPE8x86(Native) isn't working even on Ventoy 1.0.14. There's a blue screen and a computer restarts automatically. This mode works only if SSTR folder is copied onto a pendrive. Other modes are working without copying the SSTR folder. Legacy Mode

Can you fix it?

Sorry! WinPE8x86 Native has a very special PE wim file. I run into problem to make hook in it.

However, this native mode is just for very old, underprovisioned computer. 

Copy from sergeistrelec official  FAQ

This is a special mode in which a specially prepared minimal core is loaded first (without a graphical shell) and runs a script that searches for media (DVD, USB-HDD) with the assembly and mounts the "full" core.

+ Pros:
1. Fast boot to USB 1.x. Instead of the usual 5-10 minutes on USB 1.2 - about 1 minute.
2. Less memory consumption (to build Strelec - less by ~ 250MB).
3. Reduced CPU requirements (Native Mode core has been patched to work with CPUs starting with P4 / Athlon), NX-bit checking is disabled.

-Minuses:
1. Binding to the media (when you remove it, the PC will “freeze”).
2. Slower kernel operation (since everything is loaded not from a fast RAM disk, but from a slower media). In practice, special "brakes" are not felt.
3. RunScanner does not work correctly (a utility for redirecting programs to work with the registry of the target OS), redirection to the registry of the target OS does not occur.
4. For compatibility with old CPUs, support for multicore and PAE is disabled.

Note: On modern PCs, it is better to use normal boot mode.

It's too bad that it can't be done
The Native Mode has really low system requirements and loads almost instantly.
It's good even for modern PCs, because it's so fast.