Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Boot ISO Image in Legacy Boot mode started Ventoy in UEFI mode
#1
Hey,
is it possible to boot an ISO Image in Legacy boot mode using Ventoy started in UEFI bootmode?
And conversely, can I run the ISO image in UEFI boot mode when started Ventoy in Legacy boot mode?
Greetings! Smile
Reply
#2
NO.
After you boot into Ventoy's boot menu the BIOS mode was decided and fixed by the BIOS firmware and can NOT be changed anymore.
Reply
#3
(12-04-2020, 03:06 PM)longpanda Wrote: NO.
After you boot into Ventoy's boot menu the BIOS mode was decided and fixed by the BIOS firmware and can NOT be changed anymore.
Ok, thanks for reply. But will you maybe implement this feature or not?
Reply
#4
NO.
The BIOS mode is decided by the hardware firmware and can NOT be changed by software.
Reply
#5
(12-05-2020, 01:42 AM)longpanda Wrote: NO.
The BIOS mode is decided by the hardware firmware and can NOT be changed by software.
Yea, but is it possible for example with Clover (start in Legacy mode and run UEFI Boot).
Reply
#6
Colver just create an UEFI firmware emulation enviroment. It's not the native UEFI runtime envrioment of the hardware firmware.
Ventoy is based on grub2 which doesn't support emulation UEFI enviroment.
Reply
#7
(12-06-2020, 06:42 AM)longpanda Wrote: Colver just create an UEFI firmware emulation enviroment. It's not the native UEFI runtime envrioment of the hardware firmware.
Ventoy is based on grub2 which doesn't support emulation UEFI enviroment.
Ok, thanks Smile
Reply
#8
You can make an Easy2Boot USB drive with agFM and Ventoy.
You can then MBR-boot to E2B, then to Clover UEFI64, then to agFM and then to Ventoy and then boot UEFI64 payloads.
However, Clover is very hardware dependent - it does not always work nicely on all systems.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)