Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
puppy Linux 4.3.1 does not boot
#1
I like puppy Linux 4.3.1, a very small system. But on booting with ventoy, it runs into an error - see picture.
then there is only the initial ramdisk mounted.
the ISO is here: https://rapidgator.net/file/a98b4725f9d7...1.iso.html


Attached Files Thumbnail(s)
   
Reply
#2
I can't download this ISO file.
Please share with https://mega.nz/
Reply
#3
I tested the link with free access and it works flawlessly.

https://mega.nz/ displays: Your browser seems a bit outdated
Reply
#4
Try NTFS for partition 1 instead of exFAT
Reply
#5
You can try 1.0.52
Reply
#6
with 1.0.52 the screen gets completely dark after the selection, no messages are displayed. after 10 min i switch off (Laptop HP Probook 6550b)
with 1.0.50 it shows at least the start screen.

on a HP elitebook 8470p it shows normal behavior but after 60 sec it shows
iwlwifi-... firmware file req failed: -2
and does not proceed.

on a quite old HP 6735s it starts fine
---
But nice: Slacko 5.6 does now start, it also did not work before. 46 sec i cannot see any boot messages, after 56 sec the desktop comes up
on a HP 8470p Slacko 5.6 does also start.


@Steve - i cannot find any Option "Try NTFS for partition 1" in the installer tool
Reply
#7
Quote:i cannot find any Option "Try NTFS for partition 1" in the installer tool
You have to repartition yourself. 


Although, it would have been nice if Ventoy had such option.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)