10-21-2023, 03:21 PM
(This post was last modified: 10-21-2023, 03:22 PM by Geppo Smart.)
(10-14-2023, 08:32 AM)kriz84 Wrote: I tried in NAT mode too, so in this mode it must work cuz it shares my host IP Adress but it doesnt boot from PXE
also i tried Virtual Box, same problem, Bridge Mode dont boot up and NAT Mode it gets an 10.0 IP Adress, why? shouldnt it get my host IP Adress 192.168? I know this question is not related to iventoy directly, sorry but when VM boots up it have a connection
Is my dnsmasq configuration correct? anyone have ddwrt firmware and iventoy? Iam not sure if i should use External or ExternalNet, i dont understand the difference
I tested iVentoy on my QNAP running it in a Windows VM as well as in a LXC container using a DHCP server on the same subnet and it works (although I found it doesn't like to find some kind of .ima files in the ISO directory and it hangs while scanning the ISO images).
I still haven't tried to run iVentoy under QTS, anyway, in your environment you must use the "EXTERNAL" mode, not the "ExternalNet" mode, considering your DHCP server is on the same subnet as your iVentoy.
Read about third-party DHCP here:
https://www.iventoy.com/en/doc_ext_dhcp.html
"The usage scenario of External mode is that iVentoy and the third-party DHCP Server are located in the same LAN/VLAN".
"The usage scenario of ExternalNet mode is that iVentoy and the third-party DHCP Server are located in different LANs/VLANs."