(https://sourceforge.net/projects/systemr...o/download)
I've been using SystemRescue since version 8. To make it work, I had to provide additional parameters to the boot-command -
for the 32 bit-version it is img_label=VolumeName and img_loop=path_to_iso
and
for the 64 bit version only the img_loop parameter.
I've done this with the Boot Conf Replace Plugin and a modified grubsrcd.cfg and sysresccd_sys.cfg file.
This worked until the version 9.01 of SystemRescue. With 9.01 it only works with the 32 bit-version, but not with the 64 bit-version, that ends the bootprocess with an error-message that it can not find the init-files.
If I start the 64 bit-version and then press Tab, I can see that the additional parameter is been provided, but it does not work. When I select in ventoy the compatible mode by pressing Ctrl-i, then start the 64 bit-version and hit Tab, I see the original boot-command without the img_loop parameter, if I then provide the img_loop-parameter manually it starts without error, so I presume that it is an error in the plugin. I now switched back to version 9.00 for the 64 bit-version and that is working again
I've been using SystemRescue since version 8. To make it work, I had to provide additional parameters to the boot-command -
for the 32 bit-version it is img_label=VolumeName and img_loop=path_to_iso
and
for the 64 bit version only the img_loop parameter.
I've done this with the Boot Conf Replace Plugin and a modified grubsrcd.cfg and sysresccd_sys.cfg file.
This worked until the version 9.01 of SystemRescue. With 9.01 it only works with the 32 bit-version, but not with the 64 bit-version, that ends the bootprocess with an error-message that it can not find the init-files.
If I start the 64 bit-version and then press Tab, I can see that the additional parameter is been provided, but it does not work. When I select in ventoy the compatible mode by pressing Ctrl-i, then start the 64 bit-version and hit Tab, I see the original boot-command without the img_loop parameter, if I then provide the img_loop-parameter manually it starts without error, so I presume that it is an error in the plugin. I now switched back to version 9.00 for the 64 bit-version and that is working again