Hello
I just downloaded the latest 64 bit version of windows10 from May from the microsoft download site.
I check the checksum. Its good.
No problem to put in the EXFAT partition.
I boot perfectly with a computer in Legacy mode. The start of the boot is going well. But it is totally impossible to install windows because a driver is missing ...
See this picture https://filestore.community.support.micr...a6cc5dbe75 in an old discussion https://answers.microsoft.com/en-us/wind...90a1604855
I did with the French iso then the international iso in English.
I suspect the missing driver is either the one that accesses the EXFAT partition or the FAT16 partition because when I use another build tool, the installation can be done in a completely normal fashion.
I'm going to give it a try by turning the fat16 partition into fat32.
Do you know this problem?
I saved the contents of the FAT16 partition, reformatted it to FAT32 and restored the contents. But the problem remains the same!
The error message is as follows
"No device drivers were found. Make sure that the installation media contains the correct drivers, then click OK."
Could the cause be linked to the EXFAT partition !!!
In research,
I can view the contents of the FAT32 partition But I want to open what I believe is the EXFAT partition, I have the following message
You need to format the disk in drive O: before you can use IT!!
I just downloaded the latest 64 bit version of windows10 from May from the microsoft download site.
I check the checksum. Its good.
No problem to put in the EXFAT partition.
I boot perfectly with a computer in Legacy mode. The start of the boot is going well. But it is totally impossible to install windows because a driver is missing ...
See this picture https://filestore.community.support.micr...a6cc5dbe75 in an old discussion https://answers.microsoft.com/en-us/wind...90a1604855
I did with the French iso then the international iso in English.
I suspect the missing driver is either the one that accesses the EXFAT partition or the FAT16 partition because when I use another build tool, the installation can be done in a completely normal fashion.
I'm going to give it a try by turning the fat16 partition into fat32.
Do you know this problem?
I saved the contents of the FAT16 partition, reformatted it to FAT32 and restored the contents. But the problem remains the same!
The error message is as follows
"No device drivers were found. Make sure that the installation media contains the correct drivers, then click OK."
Could the cause be linked to the EXFAT partition !!!
In research,
I can view the contents of the FAT32 partition But I want to open what I believe is the EXFAT partition, I have the following message
You need to format the disk in drive O: before you can use IT!!