![]() |
Windows 10 Clean install - A Media driver your computer needs is missing - Printable Version +- Ventoy Forums (https://forums.ventoy.net) +-- Forum: Ventoy General Use —— Ventoy 使用交流 (https://forums.ventoy.net/forumdisplay.php?fid=1) +--- Forum: Ventoy Discussion Forum (https://forums.ventoy.net/forumdisplay.php?fid=2) +--- Thread: Windows 10 Clean install - A Media driver your computer needs is missing (/showthread.php?tid=441) |
Windows 10 Clean install - A Media driver your computer needs is missing - geole - 08-05-2020 Hello I just downloaded the latest 64 bit version of windows10 from May from the microsoft download site. I check the checksum. Its good. No problem to put in the EXFAT partition. I boot perfectly with a computer in Legacy mode. The start of the boot is going well. But it is totally impossible to install windows because a driver is missing ... See this picture https://filestore.community.support.microsoft.com/api/images/10a10d7d-93ae-4528-a05c-dfa6cc5dbe75 in an old discussion https://answers.microsoft.com/en-us/windows/forum/windows_10-windows_install/windows-10-clean-install-a-media-driver-your/3068a127-f088-44a2-af36-ba90a1604855 I did with the French iso then the international iso in English. I suspect the missing driver is either the one that accesses the EXFAT partition or the FAT16 partition because when I use another build tool, the installation can be done in a completely normal fashion. I'm going to give it a try by turning the fat16 partition into fat32. Do you know this problem? I saved the contents of the FAT16 partition, reformatted it to FAT32 and restored the contents. But the problem remains the same! The error message is as follows "No device drivers were found. Make sure that the installation media contains the correct drivers, then click OK." Could the cause be linked to the EXFAT partition !!! In research, I can view the contents of the FAT32 partition But I want to open what I believe is the EXFAT partition, I have the following message You need to format the disk in drive O: before you can use IT!! RE: Windows 10 Clean install - A Media driver your computer needs is missing - longpanda - 08-06-2020 When you see the message, you can press shift+F10 to lunch a cmd. In the cmd shell please check that: 1. If there is a X:\Windows\System32\ventoy.log file, and type its content 2. use diskpart to see the disk/partition/volume list and give a photo about it. Beside, I don't think it's something about exFAT, you can reformat the 1st partition with NTFS and retry. RE: Windows 10 Clean install - A Media driver your computer needs is missing - geole - 08-06-2020 Hello So i press shift +F10. I am under X:\Sources i use diskpart...... The photo is here ![]() You can see that the EXFAT partition is not listed. The RAW partition is a partition formated EXT4 So i transform the EXFAT partition on a NTFS partition and the installation can proceed normally. NOTA: I saw that an apple man has detected the same thing six months ago ( https://www.reddit.com/r/Windows10/comments/f0j44t/media_driver_missing_windows_10_installation/ ) RE: Windows 10 Clean install - A Media driver your computer needs is missing - geole - 08-06-2020 Recent news Now that windows10 is installed on the computer, I can install another version without any difficulty with a ventoy key formatted in EXFAT and FAT16. I think he discovers the driver managing EXFAT in the windows partition which has just been installed RE: Windows 10 Clean install - A Media driver your computer needs is missing - longpanda - 08-07-2020 OK, please refer https://www.ventoy.net/en/doc_disk_layout.html Quote:About Part1 |