[SOLVED] Solus 4.3 does not boot under 1.0.62

[cotton]

Hi,

Testing of the current release (1.0.62) with Solus Budgie 4.3 resulted in a blank screen and an eventual timeout script being initialised ending in a text prompt. 
Pressing the enter key several times and waiting for a change was unsuccessful. 
Same result observed for both MBR and GPT.

Surprised, as I'd read that Solus 4.2 had been tested successfully with Ventoy, I tried that release but it failed in the same way.

After discussion on the Solus forum revealed that the successful testing had been done using 1.0.41, I installed that and it worked first time!

I then updated to 1.0.62 which again led to the failure described above.

TLDR: It appears there is some regression from 1.0.41 to 1.0.62 regarding Solus but I've not tested other versions to identify when this occurred.

Not sure if it's a known issue but couldn't find any other bug report.

Please fix.

[zeit]

Try this: Ctrl+r and run the iso.

[cotton]

Try this: Ctrl+r and run the iso.

No, it still failed.

[longpanda]

Did it drop into a shell finally?
If so, run some commands and send me the log:

cat /ventoy/log
blkid

[longpanda]

I download Solus-4.3-Budgie.iso and it boot OK in my Laptop (ThinkPad T420).

[zeit]

Solus-4.3-Budgie.iso , Lenovo TP T430 Legacy -ok , UEFI -no, Ventoy 1.0.62 release.

[longpanda]

Try this CI release:
https://github.com/ventoy/Ventoy/actions...1552440057
https://www.ventoy.net/en/doc_github_ci.html

[zeit]

Solus-4.3-Budgie.iso , Lenovo TP T430 Legacy -ok , UEFI -ok - CI release.

[cotton]

Try this CI release:
https://github.com/ventoy/Ventoy/actions...1552440057
https://www.ventoy.net/en/doc_github_ci.html

Excellent, thank you. That worked.

Solus-4.3-Budgie.iso , Dell Lattitude 5300 Legacy -ok , UEFI -ok - CI release.

[longpanda]

Good.
This will be included in the next release.