re:
WinPE10_8_S.Strelec_x86_x64_2021.iso
GandalfsWindows10PE_x64_2019.iso
on Ventoy-1.0.80, MBR boot
I hope I'm not repeating information - I didn't have time to read the whole thread.
I was able to run Gandalf and Sergei Strelecs ISO's after formatting the Ventoy partition to NTFS.
It had previously been exFAT, and neither would boot.
I used the "Normal" boot mode, instead of Winboot mode, strangely.
I had first tried all the other fixit recommendations.
Then . . .
After I installed Medicat, it messed things up to a certain extent.
Medicat booted and ran fine and . . .
Srelecs ISO booted fine, booting now in Winboot mode but . . .
Gandalf booted, but none of the programs would run, showing a "bad path" type of error.
Hiren Boot CD wouldn't boot no matter what I tried.
Perhaps I can fix that by editing the Ventoy json file.
WinPE10_8_S.Strelec_x86_x64_2021.iso
GandalfsWindows10PE_x64_2019.iso
on Ventoy-1.0.80, MBR boot
I hope I'm not repeating information - I didn't have time to read the whole thread.
I was able to run Gandalf and Sergei Strelecs ISO's after formatting the Ventoy partition to NTFS.
It had previously been exFAT, and neither would boot.
I used the "Normal" boot mode, instead of Winboot mode, strangely.
I had first tried all the other fixit recommendations.
Then . . .
After I installed Medicat, it messed things up to a certain extent.
Medicat booted and ran fine and . . .
Srelecs ISO booted fine, booting now in Winboot mode but . . .
Gandalf booted, but none of the programs would run, showing a "bad path" type of error.
Hiren Boot CD wouldn't boot no matter what I tried.
Perhaps I can fix that by editing the Ventoy json file.