09-23-2022, 06:11 AM
Hello, thank you for creating an excellent USB boot tool, this is the best software of any kind I have found in 4 years, amazing. My question for this forum is, I would like to create a normal Ventoy USB, but then clone the VTOYEFI partition to a blank disk, and create a new Ventoy USB manually. I have gotten almost there, but it still will not boot. I have cloned the VTOYEFI to the new USB disk as partition 2, set ESP flag; then on partition 1 I have made FAT32, set Boot, LBA flags, named it VENTOY. Both the original Ventoy USB stick and new USB stick are MBR. When I boot to the new USB stick it says I have not set it up correctly. What step do I do next to make it work? Thank you, I am enjoying the challenge of doing this manually.