WIN10XPE fails to load

[Van Flusen]

You have to read a little bit in the forum and on ventoy.

If an ISO does not boot in the normal way there is the alternative with F1: Memdisk or extract the boot.wim and boot from the boot.wim


https://www.ventoy.net/en/doc_memdisk.html

https://www.ventoy.net/en/plugin_wimboot.html

Memdisk does work. Thanks for the reminder

Any idea why it worked without memdisk in 1.0.16 and before and now it doesn't ?

You write that WINXPE does not work with 1.0.16, 1.0.17 and 1.0.18.
cyablo writes here: https://forums.ventoy.net/showthread.php?tid=398
I used Ventoy 1.0.15. The .16 was released yesterday, I'll give it a try.
You're right! It works with 1.0.16.

I think there are too many different Bios and UEFI systems. 450 different ISO should work without problems on all systems? We must not forget that longpanda has to modify the code for some ISO to make them work. This can cause problems for other ISOs that were working before. We should not complain if we need to use Memdisk or an extracted boot.wim.