Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
puppy Linux 4.3.1 does not boot
#6
with 1.0.52 the screen gets completely dark after the selection, no messages are displayed. after 10 min i switch off (Laptop HP Probook 6550b)
with 1.0.50 it shows at least the start screen.

on a HP elitebook 8470p it shows normal behavior but after 60 sec it shows
iwlwifi-... firmware file req failed: -2
and does not proceed.

on a quite old HP 6735s it starts fine
---
But nice: Slacko 5.6 does now start, it also did not work before. 46 sec i cannot see any boot messages, after 56 sec the desktop comes up
on a HP 8470p Slacko 5.6 does also start.


@Steve - i cannot find any Option "Try NTFS for partition 1" in the installer tool
Reply


Messages In This Thread
puppy Linux 4.3.1 does not boot - by regn - 09-11-2021, 08:23 AM
RE: puppy Linux 4.3.1 does not boot - by regn - 09-11-2021, 01:49 PM
RE: puppy Linux 4.3.1 does not boot - by regn - 09-13-2021, 08:26 PM
RE: puppy Linux 4.3.1 does not boot - by Orochi - 09-13-2021, 09:21 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)